成都升降機的液壓泵站在出廠時已調定系統壓力；非專業維修人員，私自調節成都升降機泵站上的各個螺母都有可能對升降平臺的正常使用造成十分嚴重的安全隱患。但是機械設備發生故障在所難免，下面成都升降機廠家為您解析液壓泵站的調節辦法。Chengdu hydraulic pump lift in the factory has been adjusting the system pressure; non professional maintenance personnel, to adjust each lift pumping station on the Chengdu nut may have normal use of the lifting platform caused very serious security risks. However, the failure of mechanical equipment is inevitable, the following Chengdu elevator manufacturers to resolve the hydraulic pump station for you to adjust the way.

一般在21~23Mpa，如需要調高壓力，可將溢流閥帽蓋旋下，按順時針方向旋轉調壓螺釘，每旋45°，壓力約上升1.2Mpa。反之，則調低壓力；如需調節下降速度可由節流閥調節，方法：旋松節流閥的并緊螺母，然后旋轉節流閥芯（順時針為慢，反之為快），調節時每次旋轉15°左右為宜。成都升降機調節好后再并緊螺母，防止節流閥跟旋。Generally in the 21~23Mpa, such as the need to increase the pressure, the valve cap can be screwed down, according to the clockwise rotation of the pressure regulating screw, each spin 45 degrees, the pressure increases by about 1.2Mpa. On the other hand, lower pressure drop; to regulate the speed can be adjusted by the throttle valve throttle valve and method: unscrew the nut, then rotate the valve spool (clockwise to slow and fast), adjust each spin around 15 degrees. Chengdu elevator adjustment and then tighten the nut to prevent the throttle valve with spin.

成都升降機電動卸荷閥動力單元在停電時，可以通過手動放油閥實現卸荷功能，方法：旋下手動放油閥蓋形螺帽，然后逆時針方向旋轉閥芯30°，即可卸荷。卸荷結束后，再擰緊放油螺絲，繼而旋上蓋形螺帽并緊。Chengdu electric lift unloading valve power unit in the power outage, you can manually put the oil valve unloading function, manual method: unscrew the oil drain valve cap nut, then the counter clockwise rotation of the valve core 30 degrees, can be unloaded. After unloading, and then tighten the drain screw and screw on the cap nut and tighten.

成都升降機機械設備的正常運轉，就如同人之身體。“養生”好過”治病“所以設備的正常及時的保養才是保證設備壽命及設備正常運轉的關鍵。Chengdu elevator machinery and equipment, such as the normal operation of the body. "Health" better "cure" so the normal and timely maintenance of equipment is the key to ensure the normal operation of equipment life and equipment.

成都升降機做到定期更換液壓油，定期檢查各個螺母是否松動，定期檢查電器系統，定期檢查液壓系統。Chengdu elevator to replace the hydraulic oil regularly, regularly check whether each nut is loose, regularly check the electrical system, regularly check the hydraulic system.

成都升降機廠家認為，做到如上幾點，方能保證成都升降機經久不衰，持續使用。一般需要調節液壓閥門的情況發生的時候，往往是因為沒有及時更換液壓油導致液壓系統的油路堵塞造成的。Chengdu elevator manufacturers believe that, do the above, to ensure that the Chengdu elevator enduring, sustainable use. Generally need to adjust the situation of the hydraulic valve occurs, often because there is no timely replacement of hydraulic oil caused by hydraulic system caused by the blockage of the oil.